Sensaphone WEB600 Quick start Guide Uživatelský manuál stáhnout pdf

WEB600

Quick start Guide

Automatic IP Address Assignment (DHCP)

1) Connect the power supply to the WEB600 and plug into an outlet.

2) Connect a CAT5 cable to the WEB600 and plug into a 10/100 network hub or switch.

3) Install the Sensaphone Locator software from the CDRom onto a computer on the same network

as the WEB600.

4) Run the software and click Search. Find the matching MAC address (e.g. serial number located on

the bottom) of your WEB600 in the list.

5) Click on your device in the list to highlight it, then click Connect. The WEB600 web page should

automatically open in your browser.

6) On the “Setup” menu, Program the System and SMTP (email) settings.

7) On the “Zones” menu, Program the parameters for each connected sensor.

8) On the “Profiles” menu, Program the contact details for each User.

* If your network does not support automatic IP address assignment, consult the WEB600 User’s manual

for detailed instructions on alternative network configuration options.

SENSAPHONE

REMOTE MONITORING SOLUTIONS

901 Tryens Road • Aston, PA 19014 • PH: 610-558-2700 • ww.sensaphone.com

SENSAPHONE 1

Shrnutí obsahu

Strany 1 - SENSAPHONE

WEB600Quick start Guide Automatic IP Address Assignment (DHCP) 1) Connect the power supply to the WEB600 and plug into an outlet.2) Connect a CAT5 cab

Komentáře k této Příručce

Žádné komentáře

Sensaphone WEB600 Quick start Guide Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Komunikace Sensaphone WEB600 Quick start Guide. Sensaphone WEB600 Quick start Guide User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Komunikace Sensaphone WEB600 Quick start Guide